Furman M-10X E
Install an M-10x E in the top slot of your rack, and the ten switched outlets on the rear panel will turn on and protect all your equipment up to a 10-amp load. A Merit Series Power Conditioner is the perfect, low-cost AC solution for any rack mount system.
Applications Furman M-10xl
INSTRUMENTS You have a rack for your effects, preamps, tuner … Are you going to plug that into the wall? One big spike and your rig is up in smoke. Furman’s standard level surge/spike protection protects your gear from the spikes and spikes so common at gigs and practice spots. With Furman’s standard-level RFI/EMI filtering, you get a quieter sound with no pops, crackles and the local radio station coming out of your amp. Plus, dual pull-out lights (M-10Lx E) allow you to see your rack without turning on the house lights. RECORDING Can’t figure out where that sound is coming from? Does your mix sound flat? Furman’s standard RFI/EMI filtering lowers the noise floor caused by the dirty AC power entering your console or DAW. Furman’s standard peak and peak protection ensures that your sensitive digital equipment does not go crazy or burn due to everyday peaks and dips. With a capacity of 10A and eleven sockets, it is enough to power your entire home studio. DJ APARTMENT Bars, clubs and other event venues have one of the worst power sources out there – from air compressors turning on and off to light shows pulling power loads up and down, AC power can stress the circuits in your facility. Furman’s standard protection and filtration keeps the bad stuff out. PRO AUDIO When you’re performing, you never know what kind of power you’re going to get. The wear and tear of mobile platforms eventually takes its toll – so it’s smart to plug into Furman’s standard protection and RFI/EMI filtration. It keeps your equipment safe and clean. Whether you’re putting on a show at the local club or starting the church band for their next service, make sure you give them the strength they can trust.
